Chemical-assisted MMP reduction on methane-oil systems: Implications for natural gas injection to enhanced oil recovery

Abstract

Miscible natural gas injection is widely considered as a practical and efficient enhanced oil recovery technique. However, the main challenge in this process is the high minimum miscibility pressure (MMP) between natural gas and crude oil, which limits its application and recovery factor, especially in high-temperature reservoirs. Therefore, we present a novel investigation to quantify the effect of chemical-assisted MMP reduction on the oil recovery factor. Firstly, we measured the interfacial tension (IFT) of the methane-oil system in the presence of chemical or CO2 to calculate the MMP reduction at a constant temperature (373K) using the vanishing interfacial tension (VIT) method. Afterwards, we performed three coreflooding experiments to quantify the effect of MMP reduction on the oil recovery factor under different injection scenarios.The interfacial tension measurements show that adding a small fraction (1.5 wt%) of the tested surfactant (SOLOTERRA ME-6) achieved 9% of MMP reduction, while adding 20 wt% of CO2 to the methane yields 13% of MMP reduction. Then, the coreflooding results highlight the significance of achieving miscibility during gas injection, as the ultimate recovery factor increased from 65.5% under immiscible conditions to 77.2% using chemical-assisted methane, and to 79% using gas mixture after achieving near miscible condition. The results demonstrate the promising potential of the MMP reduction to significantly increase the oil recovery factor during gas injection. Furthermore, these results will likely expand the application envelop of the miscible gas injection, in addition to the environmental benefits of utilizing the produced gas by re-injection/recycling instead of flaring which contributes to reducing the greenhouse gas emissions.

Keywords

• Gas injection
• Enhanced oil recovery
• Miscibility
• Coreflooding