Design and Fabrication of an In Situ Short-Fiber Doser for Fused Filament Fabrication 3D Printer: A Novel Method to Manufacture Fiber–Polymer Composite

Abstract

Fused filament fabrication (FFF) 3D-printed parts are mostly used as prototypes instead of functional parts because they have a weaker mechanical strength compared to their injection molded counterparts. Various methods including a fiber-reinforced polymer composite were proposed to enhance the properties of FFF 3D-printed parts. A new concept to fabricate a polymer composite via FFF 3D printing is proposed, where fiber is deposited during printing, instead of using a premixed composite filament. In order to investigate the workability of this concept, a new device is needed. Firstly, the design requirements were identified, and a fiber doser that can be mounted on a commercial 3D printer was designed. Prototype testing was conducted to improve the design. The improved fiber doser was able to deposit varied fiber contents during FFF 3D printing. Thermogravimetric analysis (TGA) was used to quantify the fiber contents of the fabricated composites. With this newly designed doser, short glass fiber–polylactic acid (PLA) composites with three different fiber contents (1.02 wt.%, 2.39 wt.%, and 4.98 wt.%) were successfully manufactured. A new technique to manufacture a polymer composite is proven; nevertheless, the mechanical and tribological properties of the newly fabricated composites are under investigation and will be reported in a subsequent article.

Keywords

• short fiber-reinforced polymer
• embedding on the component
• fused filament fabrication
• 3D-printed fiber composite
• additive manufacturing