Effect of cold spray processing parameters on the microstructure, wear, and corrosion behavior of Cu and Cu–Al2O3 coatings deposited on AZ31 alloy substrate

Abstract

Cold spray coatings represent a newly emerging and recently implemented approach to enhance the poor wear and corrosion resistance of AZ31 magnesium alloy. In this study, the authors applied pure Cu and Cu-50 wt% Al2O3 composite coatings on an AZ31B substrate using the cold spray deposition method and investigated the effects of gas pressure (1, 2, and 3 MPa) and stand-off distance (1, 2, and 3 cm) on their microstructure characteristics. An increase in gas pressure from 1 MPa to 3 MPa resulted in a decrease in porosity, ranging from 33 % to 38 %, across varying stand-off distances. Increasing the stand-off distance from 1 to 3 cm resulted in a nearly four-fold rise in porosity for 2 and 3 MPa pressures and about 1.5 times for 1 MPa. The porosity increased with higher pressure due to the fragmentation of Al2O3 particles but decreased with greater spraying distance due to reduced Al2O3 retention. Additionally, the incorporation of Al2O3 particles into Cu coatings led to a significant improvement in sliding wear resistance, by up to 50 %, compared to the bare substrate. Abrasive wear and delamination were identified as the dominant wear mechanisms for the composite coatings based on friction coefficient values and micromorphology of wear tracks. Electrochemical results indicated a significant increase in the corrosion resistance of the Cu coating compared to both the bare Mg substrate and Cu–Al2O3 coating, attributed to improved resistance to galvanic corrosion.

Keywords

• Cold spraying
• AZ31B magnesium alloy
• Composite coating
• Sliding wear
• Corrosion resistance