Development of similar materials for fluid–solid coupling model testing and application in damage constitutive models

Abstract

Abstract In order to provide suitable material selection for such fluid–solid coupling model tests, orthogonal experimental studies were conducted using iron concentrate powder and barite powder as aggregates, cement as cementitious materials, and gypsum and clay as modifiers. This research showed: (1) The ATC plays a dominant role in controlling the strength indexes and water absorption of the material, and these indexes show a significant decrease with the increase of the bone adhesive ratio. For each level of ATC increase, the compressive strength decreases by 0.2 MPa, the elastic modulus decreases by 10–20 MPa, and the cohesion decreases by 25–45 kPa. (2) Mixing gypsum and cement cannot jointly promote strength growth. (3) With the increase of GTC, the water absorption rate of the material increases, while the softening coefficient and permeability coefficient decrease obviously. Gypsum, which accounts for 4–16% of cement content, can be suitable for studying the hydraulic properties of similar materials for most sedimentary rock. Based on Weibull statistical damage theory, a damage constitutive model for the entire process of rock triaxial compression under the combined action of rainwater infiltration and load was established. Due to the influence of internal pores, the experimental and theoretical results have a certain deviation, the higher the confining pressure, the more obvious the deviation. In addition, the higher the rock strength, the less obvious the deviation caused by pores. This damage model can better describe the progressive failure process of rocks after rainwater infiltration, and can provide theoretical reference for the study of slope stability caused by rainwater infiltration.

Keywords

• Similar materials
• Fluid–solid coupling tests
• Sensitivity analysis
• Hydraulic properties
• Damage constitutive model