Camera Cabling Analysis of a Remote Sensing Satellite in Terms of Electromagnetic Compatibility

Abstract

Ensuring the correct operation of electrical equipment in tandem is a critical engineering concern, particularly when addressing the issue of electromagnetic compatibility (EMC). In satellite systems, EMC considerations must be addressed from the initial design phases, as methods such as shielding or the addition of suitable filters are not always feasible or optimal. This article examines the necessity of shielding the LVDS (Low-Voltage Differential Signaling) bus cabling of the satellite's camera, which is located on the satellite's exterior. The study begins with the simulation of the LVDS bus cabling to assess the need for shielding, and the results are subsequently validated through electromagnetic compatibility testing. The research findings indicate that, while shielding the LVDS bus cable of the camera can improve protection by a factor of ten thousand in the worst-case scenario during Radiated Emission (RE) and Radiated Susceptibility (RS) tests, the low level of interference radiation in RE (approximately E7–8 V/m or E4/1–11 A/m) and the small amplitude of the interference signal in RS (approximately 0.001 V) suggest that shielding is not necessary. Shielding would only increase the satellite's mass and complicate the connection without significant benefits. It is evident from this study that simulating Conducted Emission (CE) and Conducted Susceptibility (CS) tests in subsequent design phases is essential to ensure comprehensive EMC assessment.

Keywords

• electromagnetic compatibility
• remote sensing satellite
• lvds bus
• shielding: rs
• re