Effects of Borax, Sucrose, and Citric Acid on the Setting Time and Mechanical Properties of Alkali-Activated Slag

Abstract

The setting time of alkali-activated slag (AAS) binders is extremely short, while traditional retarders of Portland cement may be invalid for AAS. To find an effective retarder with a less negative impact on strength, borax (B), sucrose (S), and citric acid (CA) were selected as potential retarders. The setting time of AAS with different admixtures dosages of 0%, 2%, 4%, 6%, and 8%, and the unconfined compressive strength and beam flexural strength of 3 d, 7 d, and 28 d AAS mortar specimens were tested. The microstructure of AAS with different additives was observed by scanning using an electron microscope (SEM), and the hydration products were analyzed by energy dispersive spectroscopy (EDS), X-ray diffraction analysis (XRD), and thermogravimetric analysis (DT-TGA) to explain the retarding mechanism of AAS with different additives. The results showed that the incorporation of borax and citric acid could effectively prolong the setting time of AAS more than that of sucrose, and the retarding effect is more and more obvious with the increase in borax and citric acid dosages. However, sucrose and citric acid negatively influence AAS’s unconfined compressive strength and flexural stress. The negative effect becomes more evident with the increase in sucrose and citric acid dosages. Borax is the most suitable retarder for AAS among the three selected additives. SEM-EDS analysis showed that the incorporation of borax does three things: produces gels, covers the surface of the slag, and slows down the hydration reaction rate.

Keywords

• alkali-activated slag
• sucrose
• borax
• citric acid
• setting time
• mechanical properties