Delignification, Yield, Defibreability, and Brightness of Pine Wood (Pinus sylvestris) Pulped Using the Alkaline Sulphite Method with the Addition of DDA and Ethylene Glycol

Abstract

Sodium sulfite (Na2SO3) is known as a selective chemical agent for wood delignification. In this work, Scots pine (Pinus sylvestris) wood was pulped using alkaline sulfite (AS) with the addition of 1,4-dihydro-9,10-dihydroxy anthracene (DDA) [called also soluble anthraquinone (SAQ)] and ethylene glycol (G). The studies showed the possibility of obtaining Kappa number (KN) 24 to 26 alkaline sulphite-DDA pine pulps with total and screened yields higher by 3.4 to 3.9% and 1.4 to 2.6%, respectively, than in the case of kraft pulping. The AS-SAQ pulping process was also characterized by much higher brightness of pulps but worse defibreability of wood than the kraft process. Increasing the amount of Na2SO3 dosed to the wood from 25% to 30-35% (based on wood) and adding G to the cooking liquor increased the delignification of pine wood in the AS-SAQ method to Kappa number of 17 to 20 units (without G) and approximately 14.5 units (with G). Such a modification had a positive effect on the defibreability of wood after pulping and the brightness of pulps but a negative effect on the screened yield of AS-SAQ and AS-SAQG pulps.

Keywords

• pine wood
• alkaline sulphite pulping
• dda
• degree of pulping
• total yield
• screened yield
• reject content in digesters pulp
• brightness