Non-contact Dynamic Capacity-Increasing of Overhead Conductor Based on Cooling Tester (CT)

Abstract

The traditional dynamic capacity-increasing technology of overhead conductors needs to monitor the operation state of conductors (temperature, sag, etc.), and the relevant sensors are usually installed directly on the surface of conductors. The installation cost is high, and the operating maintenance is complicated. In this paper, a non-contact dynamic capacity-increasing method for overhead conductors based on CT is proposed. Firstly, the theory of the non-contact dynamic capacity-increasing method for conductors is introduced, and a cooling testing device is designed according to the theory. Then, the cooling index is defined to represent the cooling capacity of the object, and the corresponding cooling indexes for the conductors and the CT are calculated based on the steady-state thermal balance equation. By establishing a cooling correlation model for the conductors and the CT, the calculation for the dynamic ampacity of the conductors can be obtained. Finally, the cooling conditions of cooling testing device at different ambient temperatures and wind speeds are calculated through the finite element simulation method. Combined with the dynamic capacityincreasing method proposed in this paper, the corresponding ampacity value are obtained, and the effect of capacity increase is analyzed. The results show that the non-contact dynamic capacity-increasing method based on the CT has obvious effect in capacity-increasing compared with the static ampacity.