MODELING OF THE MECHANISM OF ACTION OF EPILAME FILM IN THE PROCESS OF PROCESSING

Elena Zvyagina; Mikhail Selemenev; Larisa Frolenkova; Igor Kravchenko; Yury Kuznetsov; Sergey Velichko; Aleksandar Ašonja; Larisa Kalashnikova

doi:10.46793/adeletters.2022.1.1.2

Advanced Engineering Letters (Mar 2022)

MODELING OF THE MECHANISM OF ACTION OF EPILAME FILM IN THE PROCESS OF PROCESSING

Elena Zvyagina,
Mikhail Selemenev,
Larisa Frolenkova,
Igor Kravchenko,
Yury Kuznetsov,
Sergey Velichko,
Aleksandar Ašonja,
Larisa Kalashnikova

Affiliations

Elena Zvyagina: Orel State University named after I.S. Turgenev, Orel, Russia
Mikhail Selemenev: Orel State University named after I.S. Turgenev, Orel, Russia
Larisa Frolenkova: Orel State University named after I.S. Turgenev, Orel, Russia
Igor Kravchenko: Institute of Mechanical Engineering of the Russian Academy of Sciences named after A.A. Blagonravov (IMASH RAS), Moscow, Russia; Russian State Agrarian University – MTAA named after K.A. Timiryazev, Moscow, Russia
Yury Kuznetsov: Orel State Agrarian University named after N.V. Parakhin, Orel, Russia
Sergey Velichko: National Research Mordovia State University named after N.P. Ogarev, Saransk, Russia
Aleksandar Ašonja: Faculty of Economics and Engineering Management in Novi Sad, University Business Academy in Novi Sad, Serbia
Larisa Kalashnikova: Orel State University named after I.S. Turgenev, Orel, Russia

DOI: https://doi.org/10.46793/adeletters.2022.1.1.2
Journal volume & issue: Vol. 1, no. 1
pp. 8 – 15

Abstract

Read online

The article discusses the mechanism of action of the epilam film during the operation of epilated drills and the influence of cutting conditions, processing conditions on their condition. Tribological tests were carried out using a special installation, where the test conditions are close to the conditions characteristic of the drilling process. Based on the results of the experiment, it was found that the effectiveness of epilam film directly depends on the cutting speed, which determines the temperature in the contact zone. Research has shown that use of oil-based LCTF MR-7 (МР-7) has the best effect on the state of epilam coating.

Published in Advanced Engineering Letters

ISSN: 2812-9709 (Online)
Publisher: The Association of Intellectuals for the Development of Science in Serbia – “The Serbian Academic Center”
Country of publisher: Serbia
LCC subjects: Technology: Engineering (General). Civil engineering (General): Mechanics of engineering. Applied mechanics
Website: https://www.adeletters.com/

About the journal

Abstract

Keywords