Three-Dimensional Printing Enabled Droplet Microfluidic Device for Real-Time Monitoring of Single-Cell Viability and Blebbing Activity

Abstract

Droplet-based microfluidics with the characteristics of high throughput, low sample consumption, increasing reaction speed, and homogeneous volume control have been demonstrated as a useful platform for biomedical research and applications. The traditional fabrication methods of droplet microfluidics largely rely on expensive instruments, sophisticated operations, and even the requirement of an ultraclean room. In this manuscript, we present a 3D printing-based droplet microfluidic system with a specifically designed microstructure for droplet generation aimed at developing a more accessible and cost-effective method. The performance of droplet generation and the encapsulation capacity of the setup were examined. The device was further applied to measure the variation in cell viability over time and monitor the cell’s blebbing activity to investigate its potential ability and feasibility for single-cell analysis. The result demonstrated that the produced droplets remained stable enough to enable the long-time detection of cell viability. Additionally, cell membrane protrusions featuring the life cycle of bleb initiation, expansion, and retraction can be well-observed. Three-dimensional printing-based droplet microfluidics benefit from the ease of manufacture, which is expected to simplify the fabrication of microfluidics and expand the application of the droplet approach in biomedical fields.

Keywords

• 3D Printing
• droplet microfluidics
• cell viability
• cell blebbing