Crystalline Microstructure, Microsegregations, and Mechanical Properties of Inconel 718 Alloy Samples Processed in Electromagnetic Levitation Facility

Abstract

The solidification of Inconel 718 alloy (IN718) from undercooled liquid is studied. The solidification kinetics is evaluated in melted and undercooled droplets processed using the electromagnetic levitation (EML) technique by the temperature–time profiles and solid/liquid (S/L) interface movement during recalescence. The kinetics is monitored in real time by special pyrometrical measurements and high-speed digital camera. It is shown that the growth velocity of γ-phase (the primary phase in IN718), the final crystalline microstructure (dendritic and grained), and the mechanical properties (microhardness) are strongly dependent on the initial undercooling ΔT at which the samples started to solidify with the originating γ-phase. Particularly, with the increase in undercooling, the secondary dendrite arm spacing decreases from 28 μm to 5 μm. At small and intermediate ranges of undercooling, the solidified droplets have a dendritic crystalline microstructure. At higher undercooling values reached in the experiment, ΔT>160 K (namely, for samples solidified with ΔT=170 K and ΔT=263 K), fine crystalline grains are observed instead of the dendritic structure of solidified drops. Such change in the crystalline morphology is qualitatively consistent with the behavior of crystal growth kinetics which exhibits the change from the power law to linear law at ΔT≈160 K in the velocity–undercooling relationship (measured by the advancement of the recalescence front in solidifying droplets). Study of the local mechanical properties shows that the microhardness increases with the increase in the γ″-phase within interdendritic spacing. The obtained data are the basis for testing the theoretical and computational of multicomponent alloy samples.

Keywords

• Inconel 718
• electromagnetic levitation
• sharp interface model
• phase distribution