Mechanical Behavior of Dental Restorations: A Finite Element Pilot Study of Implant-Supported vs. Multiunit-Supported Restorations

Abstract

Implant-supported-screw-retained prostheses are highly popular. Some of the most frequent complications are connected with the mechanical properties of the fixing elements. These include abutment screw loosening or even screw fracture. Using an intermediate abutment can offer several advantages. However, few studies detail how this affects the mechanical behavior of dental restorations. This study focuses on understanding the mechanical behavior of implant-supported restorations with a transepithelial component compared to direct implant-supported restoration. It was carried out using the finite element method (FEM) and was experimentally validated. The results showed that in the case of transepithelial-supported restoration, the prosthetic screw mounted over the transepithelial component suffered higher stress than the one screwed directly into the implant. After applying a cyclic fatigue load, it was experimentally proven that, in the transepithelial-supported restorations, the fuse changed from being the screw that went into the implant to being the upper one. In conclusion, we can state that the use of an intermediate abutment in dental restoration not only provides better protection for the rest of the dental restoration but also allows for easier repair in the event of a fracture. This can potentially lead to more efficient procedures and improved patient outcomes.

Keywords

• finite element analysis
• dental-implant abutment design
• mechanical complications
• prosthesis failure
• cyclic fatigue
• preload