Energy-Saving Impact and Optimized Control Scheme of Vertical Load on Distributed Electric Wheel Loader

Abstract

During the operation of a wheel loader, the external load acting on the bucket undergoes many changes, resulting in significant changes in the load ratio on the front and rear axles. For this reason, controlling a standard wheel loader is not trivial. In addition, in the case of a distributed electric wheel loader (DEWL), the operating control algorithm is often complex and is, therefore, the subject of optimization studies. This study compared the electric power consumption across different vertical loads, speeds, and travel directions for single-front, single-rear, and dual-motor configurations, both during transporting and pre-shoveling operations. The analysis led to the development of control rules based on energy-saving objectives. Under the shoveling condition, it was observed that vertical loads can lead to an insufficient driving force and skidding, necessitating the proposal of a new optimized control scheme. The results revealed that the optimal solution for transporting is the single-motor drive control scheme without a mechanical connection between the front and rear motor. With the single-motor control scheme, comparing the preferred controlled motor with the unselected motor under different loads, the average electrical power savings for forward, backward, and circling were at least 3.51%, 3.12%, and 0.34%, respectively. Under the pre-shoveling condition, the optimal control scheme was identified as the single rear motor control scheme, effectively reducing electrical power consumption. In response to the issues encountered during the shoveling condition, an economical solution involving the modification of the front axle transmission ratio has been proposed, along with an optimized control scheme based on vertical load variations.

Keywords

• distributed electric wheel loader
• control scheme
• vertical load
• energy saving