Degree of conversion and molecular weight of one denture base and three reline resins submitted to post-polymerization treatments

Abstract

The effect of post-polymerization treatments (MW-microwave irradiation and WB-water-bath) on the degree of conversion (DC) of three reline resins (Ufi Gel hard-U, Kooliner-K, and Tokuso Rebase Fast-T) and one denture base resin (Lucitone 550-L), submitted to two polymerization cycles (LS-short and LL-long), was evaluated by using FT-Raman spectroscopy (n = 5). The molecular weight (Mw) of the powder of all materials and of K polymerized specimens (control; MW; and WB; n = 3) was analyzed using GPC. DC data were analyzed using Kruskal-Wallis test (a = .05). For control specimens, there were no significant differences between U (68%) and LL (77%) and among LL, K (81%), and T (84%). LS (92%) had the highest DC (P < 0.05). Only material K exhibited an increased DC after WB (P < 0.05). All powders had Mw from 4.0 x 10(5) to 6.5 x 10(5) and narrow Mw distributions (2.1 to 3.6). Polymerization and post-polymerization produced K specimens with Mw similar to that of K powder.

Keywords

• reline resin
• degree of conversion
• molecular weight
• post-polymerization treatment