Experimental Study of the Flexural Behaviour of RC Beams Made of Eco-friendly Sawdust Concrete and Strengthened by a Wooden Plate

Abstract

Abstract In this paper, the effectiveness of the strengthening by a wooden plate for reinforced concrete (RC) beams that incorporate waste sawdust (SD) as a partial substitute for fine aggregate (sand) has been investigated. To this end, two types of concrete mixtures were made: normal concrete (NC) and sawdust concrete (SDC), which was made by substituting 15% of the volume of sand with SD. Five RC beams (100 mm in depth, 200 mm in width, and 1500 mm in length) were experimentally tested for flexural behavior under four-point loading. Three strengthening schemes were used in this study. The first scheme used a wooden plate that was only fixed by an adhesive layer. The second and third schemes were applied by a wooden plate, which was fixed by an adhesive layer and steel angles (two and eleven angles). The findings of the study indicate that although the concrete's workability, compressive, and splitting tensile strengths were reduced with the addition of SD, the ultimate load of the beam with SD was lower than that of the control beam, with a slight variation of approximately 4%. Moreover, strengthening the RC beam with a wooden plate and two steel angles yielded the highest load capacity among all tested beams, 20% higher than the control specimen. The study's findings offered useful information for developing eco-friendly sawdust concrete beams with efficient strengthening techniques for potential future uses.

Keywords

• Sawdust
• Wood recycling
• Wooden plate
• Strengthening
• RC beams
• Flexural strength