Nuclear Materials and Energy (Dec 2023)
Measurements of heat flux components due to charged and non-charged particles in DIII-D divertor near and under detachment
Abstract
Surfacing Eroding Thermocouples (SETC) have been used to provide high spatial and temporal resolution heat flux measurement in DIII-D. SETCs were first tested in the lower divertor of DIII-D using the Divertor Material Evaluation System (DiMES), then an array of SETCS was permanently installed in the upper SAS-VW divertor for studying the heat flux mitigation in closed divertor geometry. SETCs proved that inducing divertor detachment with various methods is an effective way to reduce the peak heat flux at the divertor targets. In the investigated discharges the heat flux is reduced to less than 30% under detachment compared to attached conditions. A new method of using the combination of recessed SETC and flush SETC was demonstrated to be able to measure the heat flux from volumetric radiation and the charge exchange neutrals. It was observed that the magnitude of the heat flux from radiation and charge exchange neutrals increased during the process of detachment. While 30% of the total incident heat flux is attributable to the volumetric radiation and the charge exchange neutrals in the fully detached divertor condition with B×∇B drift into the divertor, it could reach more than 60% with B×∇B drift away from the divertor.