Electrical pruning of Pinus radiata epicormic growths

Abstract

A novel method for pruning epicormic growths with high voltage energy pulses is presented. This method could be utilized in autonomous forest management, for example by a drone carrying an electrical pulse generator and applicator pruning device. In a laboratory setting, short duration, high voltage pulses of electricity were generated using a capacitor network and a current source. These pulses were applied to Pinus radiata needles and the relative tissue injury to the needles was assessed by estimating electrolyte leakage from the needles in deionised water using electrical conductivity (EC) measurements. EC was positively correlated with the electrical energy applied. This validated the theory that electrical stimuli can cause increased cell death in plant matter. The cell damage, based on electrolyte leakage, caused by stimulating a Pinus radiata needle with a single 1.5 J pulse of energy was 21 % of the maximum, where the maximum was found to result in an EC of 333 µS/cm per gramme of needle in a 45 ml solution. These results from testing on needles removed from the tree confirm the potential of electrical pruning of epicormic growths. Future testing on live in-situ needles will be implemented to determine the level at which cell death induced by the application of high voltage pulses is sufficient to prune epicormic growths, given that mechanical and biotic factors of needles removed from the tree may enhance the rate of cell death in harvested samples.

Keywords

• High voltage
• Electrolyte leakage
• Electrical conductivity
• Cell death
• P. radiata
• Pine