BMC Oral Health (Jan 2020)

Technical note on introducing a digital workflow for newborns with craniofacial anomalies based on intraoral scans - part I: 3D printed and milled palatal stimulation plate for trisomy 21

  • Alexander B. Xepapadeas,
  • Christina Weise,
  • K. Frank,
  • S. Spintzyk,
  • C. F. Poets,
  • C. Wiechers,
  • J. Arand,
  • B. Koos

DOI
https://doi.org/10.1186/s12903-020-1001-4
Journal volume & issue
Vol. 20, no. 1
pp. 1 – 8

Abstract

Read online

Abstract Background Advanced digital workflows in orthodontics and dentistry often require a combination of different software solutions to create patient appliances, which may be a complex and time-consuming process. The main objective of this technical note is to discuss treatment of craniofacial anomalies using digital technologies. We present a fully digital, linear workflow for manufacturing palatal plates for infants with craniofacial anomalies based on intraoral scanning. Switching to intraoral scanning in infant care is advantageous as taking conventional impressions carries the risk of impression material aspiration and/or infections caused by material remaining in the oronasal cavity. Material and methods The fully digital linear workflow presented in this technical note can be used to design and manufacture palatal plates for cleft palate patients as well as infants with functional disorders. We describe the workflow implemented in an infant with trisomy 21. The maxilla was registered using a digital scanner and a stimulation plate was created using dental CAD software and an individual impression tray module on a virtual model. Plates were manufactured using both additive and subtractive methods. Methacrylate based light curing resin and Poly-Ether-Ether-Ketone were the materials used. Results The palatal area was successfully scanned to create a virtual model. The plates fitted well onto the palatal area. Manual post-processing was necessary to optimize a functional ridge along the vestibular fold and remove support structures from the additively manufactured plate as well as the milled plate produced from a blank. The additively manufactured plate fitted better than the milled one. Conclusion Implementing a fully digital linear workflow into clinical routine for treatment of neonates and infants with craniofacial disorders is feasible. The software solution presented here is suitable for this purpose and does not require additional software for the design. This is the key advantage of this workflow, which makes digital treatment accessible to all clinicians who want to deal with digital technology. Whether additive or subtractive manufacturing is preferred depends on the appliance material of choice and influences the fit of the appliance.

Keywords