Measurement: Sensors (Dec 2024)
Experimental void fraction measurement approach of small channel two-phase flow
Abstract
This investigation presents a novel experimental approach for assessing void fraction parameters in two-phase flows within microchannels. The study critiques the conventional impedance methods that utilize alternating current (AC) for void fraction measurements, highlighting the inherent drawbacks such as ground capacitance interference and non-uniform current distribution. To circumvent these issues, the research introduces the use of direct current (DC), which ensures a homogeneous distribution across the conductor's cross-section, as a more reliable alternative. Termed the ''Direct Impedance Method,'' this technique employs DC to enhance the accuracy of void fraction measurements. The study explores various geometric configurations of full-ring and half-ring electrodes, both vertical and horizontal, within a microchannel of 500 μm diameter. An empirical formula is derived to calculate the void fraction from the electrical data obtained. High-speed imaging at 4000 frames per second supplements the method by providing visual confirmation of the flow patterns. The comparative analysis of the direct impedance method and image processing using the homogeneous theoretical model reveals a deviation of approximately 2 %–10 % for the slug and annular flow pattern. In contrast, the deviation is more for the bubble pattern. The results affirm that the Direct Impedance Method is a cost-effective and reasonably precise technique for small-channel applications. Its accuracy is inversely proportional to the channel diameter, rendering it unsuitable for channels larger than 2 mm. The method's low construction cost further enhances its practical appeal.
