Effect of heat treatment with different heat transfer modes on the polymerization of tosylate-doped poly(3,4-ethylenedioxythiophene) films

Abstract

Abstract In this work, tosylate-doped poly(3,4-ethylenedioxythiophene) (PEDOT:Tos) films are prepared by thermally assisted oxidative polymerization either on a hot plate or in a convection oven. The main difference between these heat treatments is the way heat is transferred (conduction or convection) during polymerization. The surface morphology and structure, doped state, chemical composition, and the changes in the physical and chemical properties of the differently heat-treated films are analyzed using various instrumental methods. The hot plate-treated films exhibit a smooth and dense surface morphology with a low root-mean-square roughness of ~ 5 nm. The films have a quinoid-prevalent thiophene structure with a high electrical conductivity of 575 S/cm. By contrast, the oven-treated films show a rough and porous morphology with a surface roughness ranging from 30 to 80 nm depending on the scanning area, which yields high absorption capacity of more than 90% in the near-infrared range. The oven-treated films show a benzenoid-prevalent structure that provides relatively low electrical conductivity of 244 ± 45 S/cm. As a demonstration of these noticeable changes, PEDOT:Tos films are examined as a photothermal conversion layer to convert light energy to thermal energy, which is converted to electrical energy using a thermoelectric device by covering the films on the device.