Comparative Study of the Dimensional and Shape Accuracy of Parts Made of 316L Manufactured Using the SLM and Casting Methods after Milling and WEDM

Abstract

Parts made using selective laser melting (SLM) often require improvements to the quality of side surfaces. Therefore, the analysis of the machinability of metallic printed material is new/innovative. The surface of printed parts requires improvement in quality—surface roughness. Hence, there is a need for effective manufacturing techniques that improve the quality of the side surfaces of printed parts. In our work, we try to fill this research gap. This work comparatively analyzed the surface quality (roughness parameter Ra) after milling and wire electrical discharge machining (WEDM). The processed material was AISI 316L stainless steel, which was produced using the casting and SLM method. In the case of printed material, the influence of the direction of the tool (perpendicular, parallel) on the arrangement of sintered layers was also analyzed. The analysis of the results showed that processing the cast material and processing the material perpendicular to the arrangement of the layers gives similar results—similar relationships between the processing parameters and surface roughness were observed. However, processing parallel to the arrangement of sintered layers showed ambiguity in the relationships. Moreover, the best results of the Ra parameter (0.1–0.2 µm) were obtained for feeds of 0.08 mm/rev and 0.12 mm/rev and a cutting speed of 90 m/min. In this work, the novelty is the comparison of the surfaces of materials manufactured using different techniques (SLM, casting) after milling and WEDM processing.

Keywords

• additive manufacturing
• selective laser melting
• stainless 316L
• milling
• wire electrical discharge machining