Batch foaming of ultra-high molecular weight polyethylene with supercritical carbon dioxide: Influence of temperature and pressure

Abstract

This work is aimed at studying the foaming behavior of pure ultra-high molecular weight polyethylene (UHMWPE) with supercritical carbon dioxide (scCO2). The effects of foaming temperature and saturation pressure on the final foam structure were investigated by using two different one-step batch foaming processes. An in-situ high-pressure observing system was used to record the crystal change of UHMWPE film during heating and cooling stages with/without pressurized CO2. The results showed that the cell size and the cell density were affected by the combined effects of crystal, temperature, and pressure. Experimental results with different foaming temperatures showed that higher foaming temperatures led to larger cells and lower cell densities. In the processes of foaming during the heating stage (Proc1) and cooling stage (Proc2), the expansion ratio increased first and then decreased with the increase of temperature. Before obtaining the maximum expansion ratio, compare with Proc2, the cell size and expansion ratio of foams were smaller, and the cell density was higher in Proc1. Experimental results with different saturation pressures showed that higher pressure led to lower cell density and larger average cell diameter in Proc1 due to the reduction of crystals and melt strength. While in Proc2, higher saturation pressure led to higher cell density due to the increase of solubility of CO2, and the cell density decreased as the pressure further increased due to cell coalescence.

Keywords

• UHMWPE
• Batch foaming
• In-situ high-pressure observing system