Microstructure and Properties of Novel Mg-Al-Zn-Mn-Ca-Ni Dissoluble Alloy Fabricated by Industrial Two-Step Extrusion Method

Abstract

Dissoluble magnesium alloys for fabrication of fracturing tools have received increasing attention in recent years. However, most of the existing research is focused on the small-sized samples prepared in the laboratory, and there is almost no report on the industrial dissoluble magnesium alloys. In this study, large-scale Mg-Al-Zn-Mn-Ca-Ni alloys with a diameter of 110 mm were prepared by a semi-continuous casting and two-step extrusion method, and the corresponding microstructure and mechanical and corrosion properties were also investigated. It was found that after two-step extrusion, the mainly precipitate phases in the Mg-Al-Zn-Mn-Ca-Ni alloy are bulk-like AlMnNi, strip-like Al3Ni, and granular-like and lamellar-like Mg17Al12 phases. Due to the combined effects of grain refinement and precipitation strengthening, the Mg-Al-Zn-Mn-Ca-Ni alloy obtained excellent mechanical properties after two-step extrusion, and its ultimate tensile strength, yield strength, and elongation were 314.6 MPa, 191.2 MPa, and 13.1%, respectively. Moreover, the corrosion rate of the alloy in 3 wt.% KCl at 93 °C was as high as 97.61 mg·cm−2·h−1. This work provides a high-performance, low-cost, and large-scale alloy product for the fabrication of dissoluble fracturing tools.

Keywords

• dissoluble magnesium alloys
• two-step extrusion
• microstructure
• mechanical properties
• corrosion behaviors