Effect of probing signal on the output signals spectrum of nonlinear spin waves in a cross based on waveguides of iron-yttrium garnet film

Abstract

Subject. A change in the spectrum of spin waves (SW) in a magnetic cross is investigated when two signals pass through it: a pump signal and a probe signal. Objective. Detection of specific features in formation of the spectra of the output signals of SW in the multiport structure based on a yttrium iron garnet (YIG) film in the case of excitation of two magnetostatic surface waves (MSSW) simultaneously by the input antenna, where the first, with power higher than the first-order parametric instability threshold is the pump, and the second one is a probe. Methods. The experiments were performed for a cross structure from YIG film in the form of two orthogonal waveguides with the SW wire antennas placed at the ends of the waveguides, where one of the antennas on the transversely magnetized waveguide was considered as the input. Result. It was found that by choosing the probing signal frequency, one can significantly (by 10 dB) change the relative signal levels for the satellite waves at the output antennas, which are secondary MSSWs with some new frequencies and appear in the output signals spectrum as a result of the thresholdless processes of merging of parametric spin waves generated by MSSW pumping. In this case the secondary MSSWs frequencies can differ at the output antennas located on orthogonal waveguides. Discussion. The discovered effect is associated with the nonreciprocal nature of propagation of both the pumping wave and the waves generated at parametric instability condition in the structure.

Keywords

• parametric spin waves
• spin wave interference
• microwave guide
• spintronics
• magnonics
• micromagnetic modeling