The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences (Aug 2021)
A STUDY ON THREE-DIMENSIONAL PRINTING REPLICATION FOR USABILITY OF ARTIFACTS
Abstract
In the field of cultural heritage, replication has been performed for preservation, exhibition, and education purposes. In particular, due to advancement in computer technology, replication which combines the three-dimensional (3D) scanning and printing has widely performed. These technologies have been able to ensure morphological similarity as well as to avoid damaging artifacts in a contactless manner. In this study, a design mock-up for producing replacements was made for the purpose of preserving original forms, usability, and mass production for ritual utensils used in ancestral memorial rites annually. 3D precision scanner was used to obtain external information of ritual utensils and shape information of pattern parts. The measurements on height, width, and thickness of the body, and two handles and three feet showed fine shape differences, respectively. Therefore, representative models were selected and reconstructed. In addition, the upper and lower parts of the body, handles, and feet were separately manufactured for mass production by using sand casting. A model manufactured during the reverse design like above was completed by considering average shrinkage (4%) for the casting of copper-tin alloys. A model was completed and 3D-printed with a material extrusion technique, and a design mock-up for replication was created. In this study, a 3D printing technology was applied to ritual utensils and presented a replication methodology applicable to used artifacts. For this purpose, a model suitable for the replication method was produced based on the data obtained by 3D scanning of ritual utensils. A design mock-up, which is 3D-printed with a material extrusion technique, has enhanced design completeness by performing continuous design and dimensional inspection.