Tensile and impact behavior of 3D-printed (FeCoNi)86Al7Ti7 high entropy alloy at ambient and cryogenic temperatures

Abstract

High-entropy alloys (HEAs) demonstrate superior mechanical properties at room temperature, highlighting potential for engineering applications. With the increasing demand for advanced materials, especially in modern applications facing rigorous conditions, it becomes imperative to gain profound insights into the dynamic behavior of HEAs. In this study, the (FeCoNi)86Al7Ti7 HEA, renowned for exceptional printability and room-temperature mechanical properties, has been fabricated by selective laser melting (SLM), and its tensile and impact behaviors at ambient and cryogenic temperatures are systematically investigated. Experimental results reveal enhanced tensile properties as temperature decreases, achieving a high ultimate strength of 1313.6 MPa and impressive ductility of 24.8 % at 77 K. This improvement is attributed to the synergistic deformation mechanisms, including dislocation slip, stacking faults, Lomer and Lomer-Cottrell locks, which maintain a high strain-hardening rate and thus suppress strain localization. In contrast, impact properties deteriorate due to constrained dislocation mobility at high strain rates and low temperatures, with Charpy impact energy decreasing from 8.1 J at 293 K to 5.1 J at 77 K. Consequently, cracks readily initiate at cellular boundaries or defects, propagating in an intergranular manner and inducing localized deformation. This study provides valuable insights for the future applications of 3D-printed HEAs in extreme operational environments.

Keywords

• High entropy alloy
• Selective laser melting
• Tensile behavior
• Charpy impact
• Cryogenic temperature