Comparison of Concrete Creep in Compression, Tension, and Bending under Drying Condition

Abstract

Three types of creep experiments of compression, tension, and bending were implemented to identify quantitative relations among the three types of creep under drying atmospheric conditions. In case of the bending creep experiment, two types of unreinforced concrete beams with similar dimensions were cast for use in the beam creep and shrinkage tests. The variations in the shrinkage strain within the beam depth were measured to evaluate the effect of the shrinkage variations on the bending creep strain. The beam creep strain measured within the beam depth was composed of uniform and skewed parts. The skewed parts of the creep strain were found to be dominant whereas the uniform parts were small enough to be neglected in the bending creep evaluation. This indicated that the compressive bending creep at the top surface was close to the tensile bending creep at the bottom surface. The ratios of tensile and bending creep strains to compressive creep strain were approximately 2.9 and 2.3, respectively, and the ratio of bending creep strain to tensile creep strain was approximately 0.8. Particular attention is laid on the close agreement between tensile and compressive bending creep strains even if the creep in tension is 2.9 times larger than the creep strain in compression.

Keywords

• concrete
• shrinkage
• tension creep
• beam creep
• age-dependent concrete test