Isotropic ΙoT-Based Magnetic Flux Density Meter Implementation for ELF Field Measurements

Abstract

This article presents the basic principles for an Extremely Low Frequency (ELF) IoT-based isotropic meter implementation, which can measure magnetic flux density from 100 nT up to 10 μT. The identical sensor probes are used for isotropic field measurements in the X, Y, and Z planes. The prototype has a flat response across the frequency range from 40 Hz to 10 kHz, detecting and measuring several magnetic field sources. The proposed low-cost meter can measure fields from the power supply network and its harmonic frequencies in the operating frequency band. The proposed magnetic flux density meter circuit is simple to implement and the measured field can be displayed on any mobile device with Wi-Fi connectivity. An Arduino board with the embedded Wi-Fi Nina module is responsible for data transferring from the sensor to the cloud as a complete IoT solution, supported by the Blynk application via Android and iOS operating systems or web interface. In addition, an ELF energy harvesting (EH) circuit was also proposed in our study for the utilization of the alternating magnetic fields (50 Hz) derived from the operation of several consumer devices such as transformers, power supplies, hair dryers, etc. using low-consumption applications. Experimental measurements showed that the (DC) harvesting voltage can reach up to 4.2 volts from the magnetic field of 33 μΤ, caused by the operation of an electric hair dryer and can fully charge the 100 μF storage capacitor (Cs) of the proposed EH system in about 3 min.

Keywords

• Internet of Things (IoT)
• Extreme Low Frequencies (ELF)
• magnetic field measurements
• magnetic flux density
• magnetic field energy harvesting
• detection coil