Implementation of Non-Destructive Evaluation and Process Monitoring in DLP-based Additive Manufacturing

Abstract

This article describes a method of in-situ process monitoring in the digital light processing (DLP) 3D printer. It is based on the continuous measurement of the adhesion force between printing surface and bottom of a liquid resin bath. This method is suitable only for the bottom-up DPL printers. Control system compares the force at the moment of unsticking of printed layer from the bottom of the tank, when it has the largest value in printing cycle, with theoretical value. Implementation of suggested algorithm can make detection of faults during the printing process possible.

Keywords

• dlp
• 3d printer
• process monitoring
• fault detection
• van der waals force