Scientific Reports (Jun 2024)

A novel semi-quadratic buck-boost structures with continuous input current for PV application

  • Mustafa Okati,
  • Mahdiyeh Eslami,
  • Baseem Khan

DOI
https://doi.org/10.1038/s41598-024-65012-5
Journal volume & issue
Vol. 14, no. 1
pp. 1 – 26

Abstract

Read online

Abstract This paper recommends new design for non-isolated semi-quadratic buck/boost converter with two similar structure that includes the following features: (a) the continuous input current has made it reasonable for PV solar applications and reduced the value of the capacitors in the input filter reducing the input ripple as well as EMI problems; (b) the topology is simple, and consists of a few numbers of components; (c) the semiconductor-based components have lower current/voltage stresses in comparison with the recently recommended designs; (d) semi-quadratic voltage gain is D (2 − D) / (1 − D)2; (e) 94.6 percent from the theoretical relations and 91.8 percent from the experimental for the output power of 72W, the duty of 54.2 percent, and output voltage of 72 V are the efficiency values in boost mode; (f) 89.3 percent from the theoretical relations and 87.2 percent from the experimental for the output power of 15W, the duty of 25.8 percent, and output voltage of 15 V are the efficiency values in buck mode. One structure is the continuous output current and negative output polarity, and other structure is positive output polarity. The recommended topologies have been studied in both ideal and non-ideal modes. The continuous current mode (CCM) is the suggested mode for the proposed converters. Moreover, the requirements of CCM have been discussed. The various kinds of comparisons have been held for voltage gain, efficiency, and structural details, and the advantages of the suggested design have been presented. A small-signal analysis has been completed, and the suitable compensator has been planned. Finally, PLECS simulation results have been associated with the design considerations.

Keywords