FEATURES OF STRESSES AT THE APEX OF AN ELASTIC WEDGE, SUPPORTED BY A THIN FLEXIBLE COATING ON THE SIDES

Abstract

Objectives To study the problem of determining the degree of stress at the apex of a wedge-shaped area in cases where the sides (or one of them) are covered with a thin flexible coating.Method It is assumed that the coating is not stretchable. On the other side of the wedge-shaped area, the same coating is assumed to be present; it is either fixed, stress-free or in smooth contact with a rigid base. Mathematically, the problem is reduced to the task of determining the roots of characteristic transcendental equations arising from the existence of a nontrivial solution to the system of linear homogeneous equations.Results Values for the specific characteristics of the radial component of a stress tensor are determined for different combinations of boundary conditions and solution angles. In particular, the angles at which the singular behaviour of stresses occurs are determined. The case is considered when a special boundary condition is given on the edge surface, simulating the overlay. Characteristic equations are obtained to determine the index of the degree dependency of the asymptotic solution in its vicinity for four variants of boundary conditions. In two cases, transcendental equations are obtained, which are solved numerically.Conclusion Calculations of the first positive roots of the equations depending on the angle of the edge solution and Poisson's ratio are presented. The values of the angles, at which the singular behaviour of stresses occurs, are determined. In the case of a combination of boundary conditions (III – IV), the singular stress behaviour is observed for the angle ???? = ????/8, while in the case of (III – III) this value is equal to ????/4.

Keywords

• wedge-shaped area
• flexible coating
• stress singularity
• boundary conditions
• solution angle