Relationships between Microstructural Parameters and Time-Dependent Mechanical Properties of a New Nickel-Based Superalloy AD730™

Abstract

High temperature creep and dwell-fatigue properties of the new nickel-based superalloy AD730™ have been investigated. Three microstructures have been studied in creep (850 °C and 700 °C) and dwell-fatigue (700 °C stress control with trapezoidal signals, and dwell times ranging from 1 s to 3600 s): a coarse grains microstructure, a fine grains one, and single crystalline samples. The aim of this study is to assess the influence of the grain size on creep and creep-fatigue properties. It is demonstrated that fine and coarse grains microstructures perform similarly in creep at 700 °C, showing that the creep properties at this temperature are controlled by the intragranular precipitation. Moreover, both the coarse grains and the fine grains microstructures show changes in creep deformation mechanisms depending on the applied stress in creep at 700 °C. At higher creep temperatures, the coarse grains microstructure performs better and almost no effect is observed by suppressing grain boundaries. During dwell-fatigue tests at 700 °C, a clear effect of the mechanical cycling has been evidenced on the time to failure on both the coarse and the fine grains microstructures. At high applied stresses, a beneficial effect of the cyclic unloading to the lifetime has been observed whereas at lower applied stresses, mechanical cycling is detrimental compared to the pure creep lifetime due to the development of a fatigue damage. Complex creep-fatigue interactions are hence clearly evidenced and they depend on the pure creep behavior reference.

Keywords

• cast and wrought Ni-based superalloy
• single crystals
• creep
• dwell-fatigue properties
• high temperatures
• creep threshold stress
• inter/intra granular properties