Computational fluid dynamic (CFD) modelling of transient flow in the intermittent gas lift

Abstract

A computational fluid dynamics model (CFD) is developed for intermittent gas lift techniques. The simulation is conducted for a test section of 18 m vertical tube with 0.076 m in diameter using air as injection gas and oil as a formation fluid. The results obtained from the CFD model are validated with the experiment results from the literature. The current study shows that computational modeling is a proven simulation program for predicting intermittent gas lift characteristics and the transient flow parameters that are changing with time and position in the coordinate system. The model can predict the slug velocity behavior for different injection pressure. The slug velocity profile shows three regions; the first region is the rapid acceleration at the initial time of injection, the second region shows the nearly constant velocity until the slug reaches the surface and the third region is again the rapid acceleration when the liquid starts to produce. Also, the results obtained from this model show that as the gas injection pressure increases, the liquid slug velocity increase, and the region of the constant velocity decrease. The effect of the injection time on the liquid production rate has been studied for two different gas injection pressures of 40 psig and 50 psig. The developed model shows that more than 50% of the liquid production is coming from after flow period.

Keywords

• Intermittent gas lift
• Slug velocity
• Transient flow
• CFD
• Artificial lift