BMC Chemistry (Apr 2024)

Application of a novel deep eutectic solvent modified carbon nanotube for pipette-tip micro solid phase extraction of 6-mercaptopurine

  • Leila Raisi,
  • Sayyed Hossein Hashemi,
  • Ahmad Jamali Keikha,
  • Massoud Kaykhaii

DOI
https://doi.org/10.1186/s13065-024-01199-y
Journal volume & issue
Vol. 18, no. 1
pp. 1 – 10

Abstract

Read online

Abstract Background 6-mercaptopurine (6-MP) is a chemotherapy drug mainly used to treat leukemia. It is a persistent organic pollutant and can remain in the environment for a long period of time. The presence of 6-MP in the environment poses a number of hazards and needs to be assessed to monitor its potential risk to human health and the environment. However, due to its trace amount in complicated matrices, a clean-up and preconcentration step before its determination is compulsory. Results As a highly efficient adsorbent for the extrication of 6-mercaptopurine (6-MP), a novel carbon nanotube doped with camphor: decanoic acid deep eutectic solvent was synthesized and applied as a packing material for the pipette-tip micro solid phase extraction sorbent of 6-MP from tap, wastewater and seawater samples before its spectrophotometric determination. Characteristics and structure of this adsorbent was fully investigated. Factors affecting extraction, including type and volume of the eluent, ionic strength and pH of the sample solution, amount of adsorbent, and number of extraction and elution cycles were optimized using one-factor-at-a-time and response surface methodologies. The method was found to be linear in the range of 1 to 1000 µg/L with a limit of detection and quantification of 0.2 and 0.7 µg/L, respectively. Reproducibility as relative standard deviation was better than 4.6%. Conclusion Application of deep eutectic solvent modified carbon nanotube indicated suitable microextraction results and good potential for rapid extraction of trace amounts of 6-MP from different aqueous samples. The amount of sample required for the analysis was less than 10 mL and only 1.5 mg of the adsorbent was used. The total analysis time, including extraction was less than 15 min and the adsorbent could be used for at least 10 times, without significantly losing its adsorption ability. Compared to using unmodified usual carbon nanotubes, deep eutectic solvent doped carbon nanotubes showed 19.8% higher extraction ability.

Keywords