Surface Profile Studies of Photoinduced Gratings Made with DCG Films with Optional Papain Development

Abstract

The use of surface relief structures is increasing in the field of optics. A study of photoinduced relief using dichromated gelatin films with different thickness is described in this paper. Two light sources were used: a laser (λ = 468 nm) and an ultraviolet mercury-metal halide lamp. Gratings with low spatial frequencies were contact-copied on the DCG (dichromated gelatin) films. Two development processes were used, one included washing the plates with just water and the other with a mixture of water and papain. This enzyme is used to improve the gratings’ relief which was studied with a profilometer. For the development process with just water, it was found that when gratings were recorded using visible or UV light, the height profile inversely correlated to spatial frequencies. For short exposure times, the reliefs showed a sinusoidal profile. When visible light was used, the DCG areas where the Ronchi grating had transparent slits showed a flat relief and the areas where the Ronchi grating had opaque slits showed a round peak, with the peak being taller than the flat surface. In contrast, when UV light was used, the flat surfaces were taller than the peaks. The relief height increased up to seven times when papain was used.

Keywords

• dichromated gelatin films
• papain
• surface relief
• diffraction gratings