European Journal of Materials Science and Engineering (Jun 2021)

RESEARCH OF PHYSICO CHEMICAL PARAMETERS BEFORE AND AFTER THE USE OF THERMAL WATER IN THE PEJA BATH

  • Florent DOBROSHI,
  • Faton MALOKU,
  • Krenar DOBROSHI

DOI
https://doi.org/10.36868/ejmse.2021.06.02.106
Journal volume & issue
Vol. 6, no. 2
pp. 106 – 112

Abstract

Read online

With the development and growth of the population, the demand for quality and safe water increases. The desire for a healthy body, at the same time to cure various health problems and to enjoy the natural beauty pushed one for the sources of thermal water springs, mostly natural and rich in innumerable healing properties for each disease. The purpose of this study is to investigate the physicochemical parameters of thermal water in Banja e Pejes, where sampling sites are located at inlet water sources, during use and at some exit points after thermal water has been used by the hospital for the treatment of several different diseases. A total of 12 samples were taken in this paper. dated: 23.12 2020, where samples are in three time frames 4 samples are taken at 8:00 am, the other 4 samples were taken at 11:00 am, and the last 4 samples were taken at 16:00 pm. The assays were performed with the most advanced methods at the University of Mitrovica Laboratory, we used spectrophotometric method, comparative method and in very rare cases standard classical method of analysis. In this case we have determined: temperature, dissolved oxygen, pH, electrical fluidity, odor, taste, turbidity, nitrates and nitrite. The purpose of this research is to analyze thermal waters before and after use by the Banja e Pejes and their discharge into the environment where it can have consequences for both flora and fauna may also have an impact on the waters used for drinking where the day by day is further reduced.

Keywords