Stereoscopic Monitoring Methods for Flood Disasters Based on ICESat-2 and Sentinel-2 Data

Abstract

Climate change has led to an increased frequency of extreme precipitation events, resulting in increased damage from rainstorms and floods. Rapid and efficient flood forecasting is crucial. However, traditional hydrological simulation methods that rely on site distribution are limited by the limited availability of data and cannot provide fast and accurate flood monitoring information. Therefore, this study took the flood event in Huoqiu County in 2020 as an example and proposes a three-dimensional flood monitoring method based on active and passive satellites, which provides effective information support for disaster prevention and mitigation. The experimental results indicated the following: (1) the flood-inundated area was 704.1 km2, with the Jiangtang Lake section of the Huaihe River and the southern part of Chengdong Lake being the largest affected areas; (2) water levels in the study area ranged from 15.36 m to 17.11 m, which is 4–6 m higher than the original water level. The highest flood water level areas were the Jiangtang Lake section and the flat area in the south of Chengdong Lake, with Chengdong Lake and the north of Chengxi Lake having the greatest water level increase; (3) the flood water depth was primarily between 4 m and 7 m, with a total flood storage capacity of 2833.47 million m3, with Jiangtang Lake having the largest flood storage capacity; and (4) the rainstorm and flood disaster caused a direct economic loss of approximately CNY 7.5 billion and affected a population of approximately 91 thousand people. Three-dimensional monitoring of floods comprehensively reflects the inundation status of floods and can provide valuable information for flood prediction and management.

Keywords

• Sentinel-2
• ICESat-2
• water area extraction
• water level monitoring
• three-dimensional monitoring