The Influence of Material on the Operational Characteristics of Spur Gears Manufactured by the 3D Printing Technology

Dimić Aleksandar; Mišković Žarko; Mitrović Radivoje; Ristivojević Mileta; Stamenić Zoran; Danko Ján; Bucha Jozef; Milesich Tomáš

doi:10.2478/scjme-2018-0039

Journal of Mechanical Engineering (Nov 2018)

The Influence of Material on the Operational Characteristics of Spur Gears Manufactured by the 3D Printing Technology

Dimić Aleksandar,
Mišković Žarko,
Mitrović Radivoje,
Ristivojević Mileta,
Stamenić Zoran,
Danko Ján,
Bucha Jozef,
Milesich Tomáš

Affiliations

Dimić Aleksandar: University of Belgrade, Faculty of Mechanical Engineering, Kraljice Marije 16, 11120Belgrade35, Serbia
Mišković Žarko: University of Belgrade, Faculty of Mechanical Engineering, Kraljice Marije 16, 11120Belgrade35, Serbia
Mitrović Radivoje: University of Belgrade, Faculty of Mechanical Engineering, Kraljice Marije 16, 11120Belgrade35, Serbia
Ristivojević Mileta: University of Belgrade, Faculty of Mechanical Engineering, Kraljice Marije 16, 11120Belgrade35, Serbia
Stamenić Zoran: University of Belgrade, Faculty of Mechanical Engineering, Kraljice Marije 16, 11120Belgrade35, Serbia
Danko Ján: Slovak University of Technology in Bratislava, Faculty of Mechanical Engineering, Institute of Transport Technology and Designing, Nám. Slobody 17,812 31Bratislava, Slovakia
Bucha Jozef: Slovak University of Technology in Bratislava, Faculty of Mechanical Engineering, Institute of Transport Technology and Designing, Nám. Slobody 17,812 31Bratislava, Slovakia
Milesich Tomáš: Slovak University of Technology in Bratislava, Faculty of Mechanical Engineering, Institute of Transport Technology and Designing, Nám. Slobody 17,812 31Bratislava, Slovakia

DOI: https://doi.org/10.2478/scjme-2018-0039
Journal volume & issue: Vol. 68, no. 3
pp. 261 – 270

Abstract

Read online

The advanced development of additive technologies over the past years led to the fact that parts made by these technologies have been increasingly used in the most diverse engineering applications. One of the most famous and the most applied additive technology is 3D printing. In this paper the influence of the material type on the operational characteristics of spur gears manufactured by the 3D printing technology is analyzed, after the experimental testing performed on a back to back gear test rig, in the predefined laboratory conditions.

Published in Journal of Mechanical Engineering

ISSN: 2450-5471 (Online)
Publisher: Sciendo
Country of publisher: Poland
LCC subjects: Technology: Engineering (General). Civil engineering (General)
Website: https://sciendo.com/journal/SCJME

About the journal

Abstract

Keywords