Gas–water percolation of tight sandstone reservoirs with different pore types in the Ordos Basin

Abstract

Abstract To investigate the percolation mechanism of tight sandstone reservoirs, qualitative and quantitative methods are applied to analyze the pore structure of the Ordos Basin through scanning electron microscopy and high-pressure mercury injection. Based on gas–water relative permeability data and the visualization of real sandstone models, a gas–water displacement experiment was carried out to simulate the percolation mechanism and fluid distribution of different pore types. The results show that: ① The percolation of different pore types varies greatly, and the irreducible water saturation decreases when the reservoir properties improve. The relative permeability of gas at an irreducible water saturation increases, the width of the two-phase percolation area increases, and the percolation ability is enhanced as the reservoir properties improve. ② The gas–water displacement mode changes from fingering to uniform displacement with the improvement of pore type, which is beneficial to the formation of effective reservoirs filled with natural gas under the same hydrocarbon generation conditions. ③ The time required for the pressure relief of samples with good reservoir properties is short, and the recovery is higher with the improvement of pore type. ④ The residual water in samples with a poor pore type increases, which decreases the relative permeability of gas and recovery. A reasonable development pattern should be carried out, and the production pressure difference should be strictly controlled to maximize productivity. This study provides theoretical guidance for the development of tight sandstone reservoirs in the Ordos Basin.

Keywords

• Tight sandstone reservoir
• Pore type
• Percolation
• Sedimentary
• Ordos Basin