Investigation of antifouling properties of polypropylene/TiO2 nanocomposite membrane under different aeration rate in membrane bioreactor system

Abstract

This paper presents the results of aeration rate effect on antifouling properties of polypropylene (PP)/TiO2 nanocomposite membrane in membrane bioreactor (MBR) system in order to oil refinery wastewater treatment. For this purpose, three levels of aeration rate with specific aeration demand per membrane area (SADm) of 0.5, 1, and 1.5 m3/m2h was used. According to the obtained results, PP nanocomposite membrane showed high hydrophilicity, porosity, and high flux compared to neat PP membrane. Also, either low or high aeration rate had a negative influence on permeability and antifouling properties of neat PP and nanocomposite membranes. The analysis of fouling mechanism for both membranes based on Hermia’s model revealed that the cake formation is dominant mechanism for lower aeration rate while by increasing aeration rate, all models couldn’t predict experimental data. Meanwhile, by increasing aeration rate, chemical oxygen demand (COD) removal for activated sludge and both membranes decreased and increased, respectively. Keywords: Membrane bioreactor, Aeration rate, Polypropylene membrane, Antifouling