Fabrication of Fe60Cu40 pre-alloy bonded composites for diamond tools by microwave hot press sintering

Jiyun Gao; Li Yang; Shenghui Guo; Lijuan Jia; Fang Wang; Ming Hou

Journal of Materials Research and Technology (Jul 2020)

Fabrication of Fe60Cu40 pre-alloy bonded composites for diamond tools by microwave hot press sintering

Jiyun Gao,
Li Yang,
Shenghui Guo,
Lijuan Jia,
Fang Wang,
Ming Hou

Affiliations

Jiyun Gao: School of Chemistry and Environment, Yunnan Minzu University, Kunming 650093, China; Faculty of Metallurgical and Energy Engineering, Kunming University of Science and Technology, Kunming 650093, China
Li Yang: State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization, Kunming University of Science and Technology, Kunming 650093, China; Department of Mechanical Engineering, Iowa State University, Ames 50011, USA; Faculty of Metallurgical and Energy Engineering, Kunming University of Science and Technology, Kunming 650093, China
Shenghui Guo: State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization, Kunming University of Science and Technology, Kunming 650093, China; Faculty of Metallurgical and Energy Engineering, Kunming University of Science and Technology, Kunming 650093, China; Corresponding authors.
Lijuan Jia: School of Chemistry and Environment, Yunnan Minzu University, Kunming 650093, China; Corresponding authors.
Fang Wang: School of Chemistry and Environment, Yunnan Minzu University, Kunming 650093, China
Ming Hou: Faculty of Metallurgical and Energy Engineering, Kunming University of Science and Technology, Kunming 650093, China; School of Electronic and Telecommunication Engineering, RMIT University, Melbourne, VIC 3000, Australia

Journal volume & issue: Vol. 9, no. 4
pp. 8905 – 8915

Abstract

Read online

In this study, a microwave hot press sintering (MHPS) strategy was developed for metal-bonded diamond composites (MBDC). The main focus was on the MHPS process of Fe60Cu40 pre-alloy bonded diamond composites. The temperature rise characteristics of the metal powders were obtained within a microwave field. Further, the composition change law of the composites was determined during the sintering process by analyzing the properties and microstructure of the composites. The successful development of this strategy will provide a reliable reference for the application of microwave sintering in the fabrication of MBDC.

Published in Journal of Materials Research and Technology

ISSN: 2238-7854 (Print); 2214-0697 (Online)
Publisher: Elsevier
Country of publisher: Netherlands
LCC subjects: Technology: Mining engineering. Metallurgy
Website: https://www.journals.elsevier.com/journal-of-materials-research-and-technology/

About the journal

Abstract

Keywords