Fundamental and Applied Agriculture (Dec 2018)
Effect of corm size and growth regulators on growth, flowering and quality of gladiolus (Gladiolus grandiflorus L.)
Abstract
Gladiolus is the 8th most important in the world cut flower trade grown for its elegant attractive spikes and good keeping quality. However, the farmers in Bangladesh have limited access to the scientific cultivation of this crop, and yield and quality production of flower is low compared to other gladiolus growing countries in the world. Growth regulating chemicals have been reported to be very effective in manipulating growth and flowering of gladiolus. Therefore, an experiment was conducted at the Landscaping section of the Department of Horticulture, Bangladesh Agricultural University, Mymensingh, during the period from October 2017 to April 2018 to study the effect of corm size and growth regulators on growth, flowering and quality of gladiolus (Gladiolus grandiflorus L.). The experiment consisted of two corm sizes viz., 3-4 and 4-5 cm, and two growth regulators viz., GA3 @ 250, 500 and 750 ppm, and NAA @ 100, 200 and 300 ppm along with water as control. The two-factor experiment was laid out in a randomised complete block design with three replications. The results revealed that the corm size and growth regulators at different concentrations significantly affected various growth, floral and quality traits of gladiolus. The highest plant height, maximum number of leaves per plant, longest leaf length, maximum number of florets per spike, longest spike and rachis length were observed in 4-5 cm sized corms and GA3 @ 750 ppm, compared to rest of the treatments. Earliness in flower initiation and maximum duration of flower was observed in 4-5 cm sized corms and GA3 @ 500 ppm. Significant variations among the treatment combinations were observed for all the parameters studied. The treatment combination of 4-5 cm sized corms and GA3 @ 750 ppm was found to be best in respect of growth, floral and quality characters of gladiolus. [Fundam Appl Agric 2018; 3(3.000): 596-601]
Keywords
