Materials (Aug 2021)

Determination of the Actual Stress–Strain Diagram for Undermatching Welded Joint Using DIC and FEM

  • Nenad Zoran Milošević,
  • Aleksandar Stojan Sedmak,
  • Gordana Miodrag Bakić,
  • Vukić Lazić,
  • Miloš Milošević,
  • Goran Mladenović,
  • Aleksandar Maslarević

DOI
https://doi.org/10.3390/ma14164691
Journal volume & issue
Vol. 14, no. 16
p. 4691

Abstract

Read online

This paper presents new methodology for determining the actual stress–strain diagram based on analytical equations, in combination with numerical and experimental data. The first step was to use the 3D digital image correlation (DIC) to estimate true stress–strain diagram by replacing common analytical expression for contraction with measured values. Next step was to estimate the stress concentration by using a new methodology, based on recently introduced analytical expressions and numerical verification by the finite element method (FEM), to obtain actual stress–strain diagrams, as named in this paper. The essence of new methodology is to introduce stress concentration factor into the procedure of actual stress evaluation. New methodology is then applied to determine actual stress–strain diagrams for two undermatched welded joints with different rectangular cross-section and groove shapes, made of martensitic steels X10 CrMoVNb 9-1 and Armox 500T. Results indicated that new methodology is a general one, since it is not dependent on welded joint material and geometry.

Keywords