Experimental Research and Numerical Simulation of Laser Welding of 303Cu/440C-Nb Stainless-Steel Thin-Walled Natural-Gas Injector for Vehicles

Abstract

This paper presents the results of research on laser lap welding technology of heterogeneous materials and a laser post-heat treatment method to enhance welding performance. The purpose of this study is to reveal the welding principle of austenitic/martensitic dissimilar stainless-steel materials (3030Cu/440C-Nb) and to further obtain welded joints with good mechanical and sealing properties. A natural-gas injector valve is taken as the study case where its valve pipe (303Cu) and valve seat (440C-Nb) are welded. Experiments and numerical simulations were conducted where the welded joints’ temperature and stress fields, microstructure, element distribution, and microhardness were studied. The results showed that the residual equivalent stresses and uneven fusion zone tend to concentrate at the joint of two materials within the welded joint. The hardness of the 303Cu side (181.8 HV) is less than the 440C-Nb side (266 HV) in the center of the welded joint. The laser post-heat treatment can reduce the residual equivalent stress in the welded joint and improve the mechanical and sealing properties. The results of the press-off force test and the helium leakage test showed that the press-off force increased from 9640 N to 10,046 N and the helium leakage rate decreased from 3.34 × 10−4 to 3.96 × 10−6.

Keywords

• laser welding
• austenitic/martensitic stainless-steel welding
• numerical simulation
• helium leakage test
• laser post-heat treatment process