Development of Silk Fibroin-Based Non-Crosslinking Thermosensitive Bioinks for 3D Bioprinting

Abstract

Three-dimensional (3D) bioprinting holds great promise for tissue engineering, allowing cells to thrive in a 3D environment. However, the applicability of natural polymers such as silk fibroin (SF) in 3D bioprinting faces hurdles due to limited mechanical strength and printability. SF, derived from the silkworm Bombyx mori, is emerging as a potential bioink due to its inherent physical gelling properties. However, research on inducing thermosensitive behavior in SF-based bioinks and tailoring their mechanical properties to specific tissue requirements is notably lacking. This study addresses these gaps through the development of silk fibroin-based thermosensitive bioinks (SF-TPBs). Precise modulation of gelation time and mechanical robustness is achieved by manipulating glycerol content without recourse to cross-linkers. Chemical analysis confirms β-sheet conformation in SF-TPBs independent of glycerol concentration. Increased glycerol content improves gelation kinetics and results in rheological properties suitable for 3D printing. Overall, SF-TPBs offer promising prospects for realizing the potential of 3D bioprinting using natural polymers.

Keywords

• silk fibroin
• bioprinting
• bioink