Analysis of the Correlation between Shielding Material Blending Characteristics and Porosity for Radiation Shielding Films

Abstract

The most important factors in the manufacture of shielded sheets are shielding ratio, light weight, and tensile strength. The base material should provide a light-shielding film with strong physical shock resistance, while maintaining the shielding ratio of lead. Therefore, we studied the correlation between the porosity during the mixing process and the maintenance of the shielding film characteristics. Changes in the shielding ratio can be predicted according to the properties of materials such as polymeric silicon and tungsten oxide. Further, their tensile strength and porosity may change depending on the content of the material. Experiments were carried out for each substance based on the shielding ratio with respect to the processing conditions. For a shielding film using barium sulfate (BaSO4) and polymeric silicon, increasing the porosity by the removal of air in the same manufacturing process resulted in a tensile strength of 6.4 MPa at 22% porosity. For tungsten oxide (WO3), the tensile strength was 10.5 MPa at a porosity of 12%, and for a 0.6 mm sample, the shielding performance was very similar to 0.21 mm of Pb. The porosity during the manufacturing process affected the tensile strength and shielding performance, which were significantly different for each shielding material.

Keywords

• radiation protection
• radioactive material
• X-ray
• radiation dose
• shielding film