Wear Properties and Post-Moisture Absorption Mechanical Behavior of Kenaf/Banana-Fiber-Reinforced Epoxy Composites

Abstract

The contribution of natural lignocellulosic fibers to the reduction in wear damage in polymer resins is of interest, especially when two of these fibers can combine their respective effects. Wear properties of hybrid kenaf/banana epoxy composites have been investigated using three different total amount of fibers, 20, 30 and 40 wt.%, at loading forces up to 30 N and to sliding distances of up to 75 m. This demonstrated that the introduction of the highest level of fibers proved the most suitable for consistency of results and containment of wear with increasing load, as was also found from the morphological evaluation of wear degradation using scanning electron microscopy (SEM). Subsequently, tensile, flexural and impact properties of as-received and post-water-saturation hybrid composites were examined. The tests revealed a limited reduction in tensile and flexural strength, not exceeding 10% of the initial values, which were very high compared to similar materials, almost reaching 140 MPa for tensile strength and exceeding 170 MPa for flexural strength. In contrast, a higher standard deviation of values was found for impact strength, although the decrease in average values was only slightly above 10%. The results suggest the availability of these hybrids for wear-resisting applications in high-moisture environments, and the even more limited water absorption conferred by banana fibers added to kenaf ones.

Keywords

• kenaf
• banana
• hybrid composites
• wear properties
• water saturation
• mechanical properties