Surface self-nanocrystallization and -lubricating dependent wear resistance of austenitic steels at same initial hardness level

Abstract

In the present paper, two austenitic wear-resistant steels, namely 110Mn13 and 0Cr17Ni10Mn5Mo2 steels, were cold-rolled to a same hardness level of ∼270 HV. Mechanical properties and wear resistance under various applied loads were tested. The deformed microstructure, worn surface morphologies and wear debris were discussed to analyze the wear resistance. Results showed that a higher density of deformation twins and dislocations were generated in the 0Cr17Ni10Mn5Mo2 steel to reach a same hardness level with the 110Mn13 steel. Consequently, the 0Cr17Ni10Mn5Mo2 steel obtained higher yield strength (736 MPa) but lower ultimate strength (896 MPa), elongation (30.5%) and strain hardening rate than the 110Mn13 steel when the impact absorption energies were at a similar level of ∼170 J. The weight loss of the 0Cr17Ni10Mn5Mo2 steel reduced by over 40% compared to that of the 110Mn13 steel under the selected wear conditions. With the cold-rolled microstructure, the worn surface of both the test steels produced nanocrystalline layers. The nanocrystalline layer thickness of the 0Cr17Ni10Mn5Mo2 steel was over 5 μm, far larger than that of the 110Mn13 steel. Meanwhile, with the wear debris containing Cr-oxide adhering to the worn surface, which could facilitate the self-lubricating effect, the 0Cr17Ni10Mn5Mo2 steel presented better wear resistance than the 110Mn13 steel.

Keywords

• Austenitic wear-resistant steel
• Mechanical property
• Wear resistance
• Nanocrystalline
• Wear debris