Influence of ZnO (Nano)Rods on the Dielectric Properties of DGEBF Epoxy Exposed to Progressive Artificial Weathering for VHF/Early UHF Applications

Abstract

An as-produced epoxy material reinforced with ZnO (nano)rods for outdoor use was produced for the purpose of enclosing VHF/early UHF transceiving elements. Three different ZnO (nano)rod percentages were dispersed (0.1 wt%, 0.5 wt% and 2 wt%) in epoxy samples and were consequently exposed to an artificial weathering environment for a total period of 2880 h. SEM and XRD characterizations were followed by gravimetric, colorimetric and dielectric measurements that were conducted every 576-h AWE treatment intervals and were complemented by FTIR, UV-Vis, contact angle and gloss measurements. The composite exhibited favourable dielectric behaviour: ZnO presence inflicted minimal impact to the composites’ loss tangent, while dielectric permittivity was reduced for low ZnO content (0.1 wt%/0.5 wt%), especially until the 1152-h interval, while it suffered an increase for 2 wt% samples that was maintained from the beginning until the end of the experiment. Hence, the low-k (4–5.2) constructed material, compared to bare epoxy resin, maintained moderate loss tangent levels (0.55–0.7) in the VHF/early UHF spectrum, throughout the full AWE treatment, and also attained reduced dielectric permittivity, thus exhibiting moderate radio frequency transparency, together with enhanced endurance against environmental fatigue.

Keywords

• ZnO
• epoxy
• artificial weathering
• dielectric properties
• aging
• VHF