The Feasibility of Multiple Fixation Points in C2

Abstract

Study Design This was an analysis using three-dimensional simulation software for spinal screw placement and computed tomographic scan images. Purpose To assess the feasibility of achieving multiple (three or four) screw fixation points in C2 vertebra by using a combination of pedicle and laminar screws. Overview of Literature Secure C2 fixation using multiple screws is required or beneficial in some unique cases. However, to the best of our knowledge, no reports have analyzed the feasibility of multiple screw fixation in C2. Methods We used computed tomographic scan images with an interval of 1.0 mm obtained from 100 patients (50 men and 50 women) and screw trajectory simulation software. The diameter of all screws was set at 3.5 mm, considering its common usage in real surgery. The anatomical feasibility of placing both pedicle and laminar screws on the same side was evaluated. For all feasible sides, the three-dimensional distance between the screw entry points was measured. Results In 85% of the cases under study, both pedicle and laminar screws could be placed on both sides, allowing the insertion of four screws. In 11% of the cases under study, two screws could be placed on one side, whereas only one screw was feasible on the other side, resulting in the placement of three screws. In all 181 sides where both screw types could be inserted, the distance between their entry points exceeded 16.1 mm, which was sufficient to prevent collision between the screw heads. Conclusions The C2 vertebra can accommodate three (11%) or four (85%) screws in 96% of the cases under study.

Keywords

• c2
• pedicle screw
• laminar screw
• multiple screw fixation